Controller board soldered

On June 6, 2010 by Jesse With 2 Comments - The Beginning - Electronics

Wasting no time, I soldered the board together. These first few pics are of me getting setup to solder, and a photo of the front & back of the pcb:

(Click on images for larger version)

I spent about 4 hours completing this board, and probably another hour preparing the heat sink. The heat sink that comes with the kit is simply a cut length of aluminum that must be drilled and tapped to attached to the parts via a 4-40 screw. I went the extra step and sanded my aluminum with fine sandpaper.

Finished board:

2 Comments

  1. poker spielen September 29, 2010

    I must digg your post so other folks are able to see it, very helpful, I had a hard time finding the results searching on the web, thanks.

    – Murk

  2. autoversicherung October 21, 2010

    Very enlightening and beneficial to someone whose been out of the circuit for a long time.

    – Kris

Comments are Disabled